• With FC, OSD, PDB all integrated, Kakute AIO makes it simple and convenient to build up your drone.
  • Only one VTX module is needed to make a complete set of FPV Racing Drone.
  • Minim OSD integrated; MWOSD Firmware preloaded; OSD Config port available; OSD interface highly customizable according to you own needs.
  • 2 oz Copper PCB ensures the 120A Maximum Continuous Current.
  • Dedicated Boot button for easy firmware flashing.
  • Reinforced solder pads for trouble-free direct soldering.
  • Extremely low profile design.
  • Input voltage 7v to 42v. Power the board directly from flight pack up to 6S (on 'BAT' pad only!).
  • PDB Maximum Continuous Current 120A
  • VIN + VBAT merged - A single wire to power the board will provide voltage input and Telemetry/OSD voltage data.
  • Filtered voltage output - output 5v 800mA (and 3.3v 150mA where applicable) to power peripherals such as GPS, RX, BLACKBOX. 5v/3.3v RX selectable.
  • Cleanflight support (RACE target).
  • BLHeli flashing supported by hardware 
  • Raceflight ready
  • Betaflight ready


  • STM32F303CCT6(256kB flash) 32-bit processor
  • MPU6050 Gyro/Accelerometer
  • ATmega328P with Arduino Bootloader(minim OSD)
  • MAX7456 Monochrome On-Screen Display(minim OSD)
  • FTDI Cable Compatible Pinout(minim OSD)
  • High quality, gold plated PCB
  • Micro USB connector for programming
  • Dimensions: 36x47.5x7mm (includes USB in height)
  • Mounting Holes: 30.5mm square to center of holes 
  • Weight: 7g



. 1x Kakute Flight Controller

. 1x 80mm XT60 connector wire

Write a review

Please login or register to review

Kakute AIO_v1.0

  • Brand: HOLYBRO
  • Product Code: FCR-0011
  • Availability: Out Of Stock
  • Rp425,000

Tags: fc, flight controller